DIY-
PACK
A factory-grade STL bundle, paint-by-numbers stencils, raw filament codes, and assembly protocols. Manufactured at home, deployed on the host machine.
Pack Manifest
マニフェストSTL/3MF bundle layout. Helmet, chest, limbs, greebles, stencils.
Print Settings
印刷設定Calibrated layer heights, infill, wall counts, supports.
Assembly Protocol
組立手順Snap-fit sequence, fastening points, alignment marks.
Pack Contents
Helmet & Faceplate
Includes optical cutouts
Chest & Pauldrons
Vented for thermal clearance
Limb Plating
ROM tested @ ±90°
Greebles & Decals
Vinyl + 3D
Stencil Sheets
Paint-by-numbers
Filament Codes
Bambu / Polymaker matched
Print
Calibration
Default profile for Bambu X1C with 0.4mm hardened steel nozzle. Adjust at your own risk.
Slicer Profile
- Layer Height0.16 MM
- Infill30% GYROID
- Walls4
- Top / Bottom5 / 5
- SupportsTREE / 75°
- Bed Temp65 °C
- Nozzle260 °C
- Speed180 MM/S
Tested Hardware
- Bambu X1CVERIFIED
- Bambu P1SVERIFIED
- Prusa MK4VERIFIED
- Voron 2.4PARTIAL
- Ender 3 V3PARTIAL
- Resin / SLAINCOMPATIBLE
Snap-Fit Protocol
Inventory
Confirm all 140 parts against the manifest. Inspect for warping, layer separation, or shrinkage. Discard out-of-tolerance prints.
Calibrate Host
Power down the host machine. Remove existing OEM plates per the chassis manual. Identify mounting points using the alignment marks.
Snap & Verify
Apply firm pressure at the marked clip points until each piece audibly seats. Verify ROM through full kinematic range before powering up.
License & Usage
Provisioning packs are licensed for personal, non-commercial use only. Resale, mass reproduction, or commercial deployment requires a B2B agreement with GRAFT 外装. Modifications for personal fitment are permitted and encouraged.
Coming Soon
The DIY Provisioning Pack drops alongside the first physical kit release. Check back soon.